|
|
|
With the cone in place on the tool, roll a
lunker collar onto the barrel
of the tool.
Multiple collars can be loaded onto the tool if desired.
|
|
 |
|
Place the desired number of lunker
layers onto the
hook. Up to 8 layers can be placed onto the hook. 8 layers
will make a 72 strand skirt. |
|
|
|
Pull the skirt layers through the tube until about half of the bundle
is out of the tube. Roll the collar off the tube and onto the
layers. Note: Different skirt lengths can be achieved by
where you place the collar on the layer bundle. Remove the wire
hook, trim the solid ends and the skirt is finished. |
|
|
|
You can make full length lunker skirts or you can make standard
lengths skirts with the lunker strand width by cutting the lunker layer
in half and then making the skirt. |
